Heath Zenith HEATH SL-7001 Manual de usuario descargar pdf

Solar Powered

Motion Sensor Light

Model SL-7001

FEATURES

• Turns on light when motion is detected.

• Automatically turns light off.

• Photocell keeps the light off during daylight hours.

• Battery Protection Circuitry. Unit will shut down when

battery is low. Unit will automatically resume operation

when battery is recharged to a safe level.

REQUIREMENTS

• Do not turn the light on before the battery is fully charged.

Charge the battery by keeping the switch in the OFF

position and the solar collector pointed directly at the

noon sun for 3 sunny days. If not fully charged, the unit

will not work.

• When FULLY charged, the solar light will operate a

maximum of 15 days without sunlight. Actual operating

time will vary depending upon how frequently the light

is triggered.

Light

Battery

Case

Sensor

3. Mounting Screws (2 sizes)

1. Solar Light Fixture

2. Solar Panel

Tapered Screw (3)

Round Head Screw (2)

UNPACKING

Be sure to remove all contents from packaging and verify

all items are present before assembling this light ﬁxture.

This package includes the following items:

INSTALLATION

For best performance, mount the ﬁxture about 8 feet (2.4

m) above the ground.

1. Mount solar panel base on a solid surface using

three tapered screws

. Adjust the panel to point directly

at the noon sun. Avoid obstructions such as trees or

buildings that may block sun light. Allow for enough

wire to reach the case. Keep ball joint at bottom.

Note: You will want to re-aim the solar panel as the

seasons change to keep it pointed directly at the noon

sun.

Three Mounting Holes for Solar Panel Base

2. Mount the battery case on a solid surface using

two round-head screws and the keyholes on the

back of the case.

3. Adjust sensor. For proper operation, the sensor

head must be rotated so that the sensor controls face

downward as shown below.

Mounting Holes (3)

Mounting

Holes (2)

4. Plug the solar panel cable into the bottom of the battery

case. IMPORTANT: Allow the battery to charge

with three days of sunshine before testing.

Controls

Light

Battery Case

Sensor Joint

Clamp

IMPORTANT: The controls must face downward to

avoid damage from rain. If controls face upward, move

sensor to the original down position, rotate 180°, then

raise to the position shown below.

Light Joint Clamps

Lense Removal

Tab

Sensor

1 2 3 4 5 6 ... 11 12

Indice de contenidos

Pagina 1 - Motion Sensor Light

Solar PoweredMotion Sensor LightModel SL-7001FEATURES• Turns on light when motion is detected.• Automatically turns light off.• Photocell keeps the

Pagina 2 - THINGS TO REMEMBER

10595-5291-074. Brancher le câble du panneau solaire sous le boîtier de la pile. IMPORTANT : Laisser la pile se charger pendant trois jours ensole

Pagina 3 - BATTERY REPLACEMENT

11595-5291-07FONCTIONNEMENTPlacer le commutateur du capteur en position AUTO pour un fonctionnement normal. Si vous n’avez pas besoin d’éclairage, p

Pagina 4 - TROUBLESHOOTING GUIDE

12595-5291-07GARANTIE LIMITÉE DE 5 ANSIl s’agit d’une « Garantie limitée » qui vous confère des droits juridiques spéciﬁques. Vous pouvez également jo

Pagina 5 - Luz detectora de

2595-5291-07TEST AND ADJUSTMENTNOTE: Sensor has a 30 second warm up period before it will detect motion. When switching modes wait 30 seconds.1. Sli

Pagina 6 - PRUEBA Y AJUSTE

3595-5291-07SPECIFICATIONSRange ... Up to 60 ft. (18.3 m); [varies with surrounding temperature]Sensing Angle ... U

Pagina 7 - ESPECIFICACIONES

4595-5291-07FIVE YEAR LIMITED WARRANTYThis is a “Limited Warranty” which gives you speciﬁc legal rights. You may also have other rights which vary fro

Pagina 8 - SERVICIO TÉCNICO

5595-5291-07Luz detectora de movimiento conalimentación solarModelo SL-7001BombillaCaja para la bateríaDetector3. Tornillos de montaje (2 tamaños)1. A

Pagina 9 - Éclairage à détecteur

6595-5291-074. Enchufe el cable del panel solar en la parte inferior de la caja de la batería. IMPORTANTE: Deje que la batería se cargue durante tres

Pagina 10 - couverture maximale

7595-5291-07FUNCIONAMIENTOPonga el interruptor del detector en AUTO(mático) para una operación normal. Si no se necesita la luz, ponga el interruptor

Pagina 11 - REMPLACEMENT DE LA PILE

8595-5291-07GUÍA DE ANÁLISIS DE AVERÍASSÍNTOMA POSIBLE CAUSA SOLUCIÓNLas luces no se prenden. 1. La batería está muerta.2. El detector está APAGADO.

Pagina 12 - GUIDE DE DÉPANNAGE

9595-5291-07À suivreÉclairage à détecteur de mouvements, à énergie solaireModèle SL-7001D’éclairageBoîtier de la pileDétecteur3. Vis de montage (2 for

Comentarios a estos manuales

Sin comentarios

Heath Zenith HEATH SL-7001 Manual de usuario

Busca en linea o descarga Manual de usuario para Los detectores de movimiento Heath Zenith HEATH SL-7001. Heath Zenith HEATH SL-7001 User's Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Los detectores de movimiento Heath Zenith HEATH SL-7001